Therminon

The number 1 supplier of underfloor heating in the Netherlands

Therminon is a leading manufacturer and supplier of innovative underfloor heating systems. We specialize in the development and manufacture of composite (plastic) manifolds and control units for underfloor heating and cooling. Here, maximum comfort is achieved with minimal energy. All our distributors are prepared for sustainable, low-temperature heat and cold sources (heat pumps, hybrid systems, etc.) and therefore the appropriate distributors for the future. Both in residential and commercial buildings.

Efficient, comfortable and energy efficient
Therminon's composite manifolds allow very comfortable, reliable and (energy) efficient heating and cooling. Moreover, cooling is very economical. Because composite is an excellent insulator, the transfer of heat and cold through the manifolds to the outside is prevented. In combination with the insulating air chambers in the distributors, the risk of condensation is even completely eliminated. Corrosion and/or rust are impossible, resulting in high reliability as well as a long service life of our manifolds.

Modular construction
Our composite manifolds are modular and easily expandable. The manifolds can also be used both hydraulically neutral and hydraulically active, thanks to a unique (patented) pump module with a low-temperature heating valve. Installers have a standard choice of static (flow) or dynamic (auto flow control) control. In addition, our systems can be delivered turnkey, including wire mesh, piping, insulation materials and zone controls.

Prefab solutions
If required, Therminon also supplies prefabricated solutions. Here, a custom solution is devised in close cooperation with the installer and pre-assembled on special frames. After quality control, all products are delivered just-in-time to the construction site where they can be installed immediately. Thanks to Therminon's prefab service, substantial savings can be made on lead times, while assembly is taken to the highest level. Optimal operation of your floor heating systems is the result.

Development and production entirely in the Netherlands
The development and production of our composite distributors takes place entirely in Bladel (near Eindhoven). This makes us unique in the Dutch market and creates great confidence among installers and end users. After all, we are always close by. We have maximum control over our production and the lines are short. Moreover, our distributors are developed and assembled specifically for the Dutch market. As a company we are independent of middlemen and high transport costs are not an issue either, allowing us to offer competitive prices. Ordered today is almost always delivered tomorrow.